Table of Contents
Advertisement
Figure 38: StoreOnce 3620 and 3640 iLO port location
The StoreOnce 5200, 5250, and 5650 Systems iLO port is in the same location.
Initial StoreOnce network configuration
The initial network configuration contains a single Port Set on a 1 GbE network containing one subnet.
This Port Set is configured to use IPv4 DHCP for management, NAS (NFS/CIFS), Catalyst and
Replication, and RMC iSCSI traffic. This configuration is the typical network connection for the StoreOnce
Management Console. You can edit the configuration to cater for the requirements of your networking
environment.
For example:
•
You may want to use a bonded Port Set for the StoreOnce Management Console.
•
You may want to configure the remaining network ports for dedicated backup and/or replication and
StoreOnce Catalyst Copy.
•
You may want to configure VLAN subnets.
•
You may want to configure dual stack subnets (IPV4 with IPv6)
Ensure that you understand your hardware and networking environment before creating the configuration.
For additional information, see the user guide.
Licensing
Full license entitlement
•
Cloud Bank Storage Read/Write license: Enables connection to Cloud storage through a Cloud
Service Provider. The cloud storage license provides cloud capacity in 1 TB increments. The
maximum is 1,000 TB total in the cloud.
•
Cloud Bank Storage Detach license: Allows the system to archive and disconnect from a cloud store
and place it in archive mode.
•
Security license: Enables the security features of Data at Rest Encryption and Data in Flight
Encryption.
•
Fibre Channel Optional Hardware license: Allows the use of an optionally added Fibre Channel
card. The license comes with the card.
•
Network Interface Optional Hardware license: Allows the use of an optionally added 10GbE-T and
10/25Gb SFP network card. The license comes with the card.
Configuring a newly installed system
125
Hide quick links:
Advertisement
Table of Contents
