Installation - COZY PILOT PRO Series Installation And Operating Instructions Manual

Step 6
- Remove the door from the heater housing.
- Locate the Pilot Pro in the carton and remove the cover from
baseplate with a screwdriver.
- Check the inside of the housing for safety labels. Try to avoid
drilling through any pertinent safety information during this step.
USE THE MOUNTING PLATE (3)
FOR THE FOLLOWING STEPS.
MOUNTING PLATE MUST BE MOUNTED AS DIRECTED
BELOW OR WIRE HARNESS WILL NOT REACH.
1. PLEASE NOTE
Do not mount the PilotPro any higher than the top of the
access door of the housing.
2. PLEASE NOTE
Align the PilotPro very close to the back edge of the housing.
3. PLEASE NOTE
Be sure to face the notch / cutout of the mounting plate (3)
toward the wall.
4. Using the mounting plate (3) as a template, align in place as
illustrated. Using a marker or pencil, leave a mark for the three
hole locations on the metal housing.
SET ASIDE THE MOUNTING PLATE ( 3 ) .
DO NOT DRILL DIRECTLY THROUGH MOUNTING PLATE.
DRILL MAY CRACK THE MOUNTING PLATE.
5. Drill the three holes into housing using a 3/16" drill bit.
A
OF THIS STEP.
B
OF THIS STEP.
Left Right
Side of Side of
Heater Heater
C
OF THIS STEP.

INSTALLATION

Page 9
3
A
B
Install on the right
side OR left side of
the housing.
C
C
3
A
B
1018039-B