Installation - COZY PILOT PRO Series Installation And Operating Instructions Manual

WARNING: PLEASE USE CAUTION WHILE INSTALLING THE ELECTRICAL CONNECTION
Step 2
Reattach the front panel housing on the heater.
NOTE: Leave the access door open until installation has
been complete.
Step 3
Direct the control module
wires (2) through the small
notch on the side of the
mounting plate (3).
Tuck the wires around
the edge of the heater
housing, against the
wall, and inside
the heater.
On the inside of the heater, you will see orange
and black wires extending from the burner.
Lead the orange pilot ignitor wire (14) and black
flame sensor wire (16) out of the heater beside
the wires you have just directed in.
Run a cable tie (25) through the
25
small hole beside the notch on the
mounting plate (3).
Gather and secure the wires to
and from the Control Module (2)
with the cable tie (25).
3
1018039-B
PILOT PRO ELECTRICAL CONNECTION
2
3
Page 20
Make sure there are no sharp
edges on the rim of the heater
housing that could potentially
damage the wires.
2
3
14
16
16
14