Step 9
Verify again that gas to the
appliance has been shut off.
Disconnect the gas line
from the current valve.
Extract the burner assembly by
removing the two screws holding it in
place (See illustration to the right).
NOTE: Keep screws for re-installation.
Step 10
1. Disconnect all wiring.
2. Disconnect pilot tube from the pilot
assembly. NOTE: Do not lose pilot
orifice. It may want to fall out of
pilot once tube is disconnected.
3. Remove valve from the
burner assembly.
INSTALLATION
PILOT
Page 11
PILOT
ADJ
PILOT
ADJ
ADJ
1018039-B