Tynetec Entel i2 Installation Manual page 14

7. PROGRAMMING
7.07 ENABLE/DISABLE FLAT NUMBER SPEECH DURING RING
If enabled the door panel will announce the flat number being called. If disabled the door panel will announce
"Calling Flat" only (no number spoken).
Press 7  and a message will announce "Flat Numbers Disabled" (e.g. current setting)
Press 1  and a message will announce "Flat Numbers Enabled – Ready"
Or press 0  and a message will announce "Flat Numbers Disabled – Ready"
7.08 SET CALL TIME
This is the duration of speech between the door panel and a telephone. When this time expires, or if the telephone is
hung‐up, the call will be cancelled. Pips will sound 10 seconds before the call cancels.
Press 8  and a message will announce "Call Time 60 Seconds" (e.g. current setting)
Enter a new call time SS (1 to 99 seconds) followed by 
A message will announce the new call time setting "Call Time SS Seconds – Ready"
7.09 SET LOCK TIME
This is the duration the door lock will remain released for from a telephone, the Trade button or EXLK input.
If a door contact is fitted this timer will be reset 2 seconds after the door has been closed.
Press 9  and a message will announce "Lock Time 10 Seconds" (e.g. current setting)
Enter a new lock time SS (1 to 99 seconds) followed by 
A message will announce the new lock time setting "Lock Time SS Seconds – Ready"
7.10 SET PRIVACY TIME
This is the duration for which a telephone can be turned off by the user (1 to 99 minutes). If set to "0" the telephone
can be switched on/off manually without a timed automatic reset.
Press 10  and a message will announce "Privacy Time 10 Minutes" (e.g. current setting)
Enter a new privacy time MM (1 to 99 minutes) followed by  (enter 0 for on/off)
A message will announce the new privacy time setting "Privacy Time MM Minutes – Ready"
7.11 SET DOOR AUDIO LEVEL
This allows the volume of speech at the door panel loudspeaker to be set.
Press 11  and a message will announce "Door Audio Level 3" (e.g. current setting)
Enter a new audio level (1 to 5) followed by  (1 = lowest)
A message will announce the new audio level setting "Door Audio Level 4"
7.12 SET HANDSET AUDIO LEVEL
This allows the volume of speech at the telephone earpiece to be set.
Press 12  and a message will announce "Handset Audio Level 3" (e.g. current setting)
Enter a new audio level (1 to 5) followed by  (1 = lowest)
A message will announce the new audio level setting "Handset Audio Level 4"
7.13 SET NUMBER OF RING CYCLES
This is the maximum duration that the telephone will ring for (1 ring cycle = approx 4 seconds). The telephone will
stop ringing when the handset is lifted. If the maximum number of ring cycles is reached without the telephone being
answered the call will cancel and the door panel will announce "Sorry – Not Available".
Press 13  and a message will announce "Handset Ring Cycles 5" (e.g. current setting)
Enter a new number of ring cycles (1 to 10) followed by 
A message will announce the new ring cycles setting "Handset Ring Cycles 10"
Doc No. FM0589 issue A Page 14