Thread Depth Indicator - vogel's PFW 6854 Installation Manual

Thread Depth Indicator

1. Insert the thread depth indicator (supplied) through the thread inserts found on the back of the flat panel to make sure the inserts
measure the same full depth and mark it (Figure 1).
2. Locate the correct diameter screw for the thread insert. Compare your marking to the screws (supplied).
3. If your selected screw is longer than the marking on the thread depth indicator, DO NOT USE this screw.
4. The screw length must not bypass the marking. Select another screw size (Figure 2 and 3), until you find one that comes closest to
your mark without going past.
Installation Instructions
Figure 1
Screw
Marking
Thread Depth
Indicator
Figure 2
Inverted Flat
Panel Display
Marking the
Depth
Thread Insert
Thread Depth
Indicator
Screw
Marking
Thread Depth
Indicator
Figure 3
PFW 6854
Page 5