vogel's PFW 6854 Installation Manual page 10

The PFW 6854 is shipped with a safety knurl knob already installed. If the user decides to incorporate the optional security hardware,
the following steps will show the user how to effectively remove the safety knurl knob and install the optional Lock-It™ hardware
kit.
NOTE: The M6 security head screw will be installed after the PFW 6854 has been fully assembled. Installation
of the M6 security head screw prior to completing assembly will not allow the PFW 6854 to function properly.
M6 x 12mm
Security Head
Screw (Qty 1) and
Lock Washers
(Qty 2)
Step 1
Remove the PFW 6854 from the packaging and
remove the existing safety knurl knob. Remove the
universal bracket bar.
Step 3
Once inserted into the mounting point, fully tighten
into place using the security Allen wrench.
Page 10
Lock-It™ Security Hardware Pack
M6 Security Head Screw
Safety Knurl
and Lock Washers
Knob
Universal
Bracket Bar
M6 Security Head Screw
and Lock Washers
Security Allen
Wrench
(Qty 1)
Allen
Wrench
Step 2
Place the two lock washers onto the M6x12mm security head
screw. Place the M6x12mm security head screw onto the
security allen wrench and insert into mounting point.
Step 4
Once the M6 security head screw has been installed, re-insert
the safety knurl knob. Installation completed. This will prevent
the display from being removed from the
PFW 6854
Safety Knurl
Knob
assembly.
Installation Instructions