StorNext QM1200, QS1200 or QS2400 Base System - Replacing a Controller Battery
2.
Move the locking handle down to pull the failed controller battery out of the controller canister
Figure 8 Battery and Locking Handle in the Controller
3.
Remove the failed controller battery by sliding it towards the rear of the controller canister.
4.
Insert the new battery into the controller canister by sliding the new controller battery towards the front of the
controller canister.
NOTE Ensure that the battery slides under the side guide pins as you continue to slide the battery to correctly seat it against the
back surface.
5.
Move the locking handle up to secure the new battery circuit board to the controller canister.
1.
Top Cover Latch Buttons
2.
Battery Circuit Board
3.
Locking Handle
ATTENTION If the battery is not correctly seated, you will not be able to reinstall the top cover on the
controller canister as directed later. If you suspect that the new battery is not correctly seated, you might
need to slide the new battery out and insert it again.
Quantum Corporation
- 7 -
April 2015
(Figure
8).