Power Connection - Infortrend EonStor GSe Pro 208 Hardware Manual

Connecting expansion systems
Connect the expansion systems using the on-board SAS expansion ports.
IMPORTANT! Only use slot 2 to install the SAS expansion host board.
2.3.4

Power connection

Before connecting to a power source, ensure that all components are properly installed and the
management interfaces are properly connected.
Take a look at the list below and check the following:
1. The hard drives are correctly installed to the drive trays.
2. All drive trays are installed to the system, whether or not they contain a hard drive.
3. The system is connected to host computers, management computers, or external networking
devices with the correct cables.
IMPORTANT! Ensure to use the power cables with at least 1.2 meters in length. DO NOT use
extension cables as the power cables are designed to connect ONLY and DIRECTLY to relocatable
power taps (RPTs) on server cabinets.
4. Ensure that the ambient temperature is lower than 40°C.
2-12 Chapter 2: Hardware installation