Table of Contents
Advertisement
•
Use a slightly moistened paper sheet or cloth for cleaning. Avoid using liquid or sprayed detergent.
•
When replacing components, insert them as gently as possible while assuring full engagement.
Vibration and shock can easily damage hard drives.
•
Only qualified service personnel should open the enclosure.
•
Contact service personnel if any of the following situations occurs:
•
The power cord or plug is damaged.
•
The enclosure has been exposed to moisture.
•
The system has not been working properly.
•
The enclosure was dropped against a hard surface.
•
The enclosure shows obvious signs of breakage.
•
To move the enclosure, more than one person might be necessary due to its weight. Drives should
be removed from the enclosure beforehand.
Important notice
The use of Infortrend certified components is strongly recommended to ensure compatibility, quality,
and normal operation with your Infortrend products. Please contact your distributor for a list of Infortrend
certified components (e.g. SFP, SFP+, HBA card, iSCSI cable, FC cable, memory module, etc.).
ESD precautions
•
Handle the modules by their retention screws, ejector levers, or the module's metal frame/faceplate
only. Avoid touching the PCB boards or connector pins.
•
Use a grounded wrist strap and an anti-static work pad to discharge static electricity when installing
or operating the enclosure.
•
Avoid dust, debris, carpets, plastic, vinyl, and Styrofoam in your work area.
•
Do not remove any module or component from its anti-static bag before installation takes place.
•
Drives must not be stacked on top of each other without their protective drive trays. Even when
drives are fixed in the drive trays, contacting the exposed PCB or rear-side interface may damage
the drives.
About this manual
The manual introduces hardware components of EonStor GSe Pro 200 Series storage system and
expansion enclosures. It also describes how to install, monitor, and maintain them.
•
For non-serviceable components, please contact our support sites.
•
Firmware operation: Consult the Firmware User Manual on the CD-ROM.
•
EonOne software: Consult the EonOne User Manual on the CD-ROM.
vi
Hide quick links:
Advertisement
Table of Contents
