Nord Drivesystems NORDAC FLEX SK 210E Series Brief Instructions page 83

Pos : 660 /Anleitungen/El ektr oni k/FU und Starter/6. M eldung en zum Betriebsz ustand/Stör meldung en (Auflistung)/F ehl er E011 [SK 180E ... SK 5xxE] @ 2\mod_1347453318765_14638.doc x @ 46627 @ @ 1
E011 11.0 Control terminals,
"Customer Unit"
Pos : 661 /Anleitungen/El ektr oni k/FU und Starter/6. M eldung en zum Betriebsz ustand/Stör meldung en (Auflistung)/F ehl er E012 [SK 180E/SK 2xxE/SK2xxE-FD S] @ 2\mod_1347454267926_14638.doc x @ 46727 @ @ 1
E012 12.0 External watchdog
12.1 Limit moto./Customer
"Motor switch-off limit"
12.2 Limit gen.
"Generator switch-off limit"
12.3 Torque limit
12.4 Current limit
12.5 Load monitor
12.8 AI minimum,
"Analog In minimum"
12.9 AI maximum,
"Analog In maximum"
Pos : 662 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265496 @ @ 1
BU 0240 en-US-3118
6 Operating status messages
Error analog – digital – inverter
• Internal customer unit (internal databus) faulty or
damaged by radio radiation (EMC)
• Check control connections for short circuit.
• Minimize EMC interference by laying control and
power cables separately.
• Device and shielding must be well grounded.
The Watchdog function is selected at a digital input and the
impulse at the corresponding digital input is not present for
longer than the time set in parameter P460 >Watchdog
time<.
• Check connections
• Check setting P460
The drive switch-off limit (P534 [-01]) has triggered.
• Reduce load on motor
• Set higher value in (P534 [-01]).
The generator switch-off limit (P534 [-02]) has triggered.
• Reduce load on motor
• Set higher value in (P534 [-02]).
Limit from potentiometer or setpoint source has switched off.
P400 = 12
Limit from potentiometer or setpoint source has switched off.
P400 = 14
Switch-off due to overshooting or undershooting of
permissible load torques ((P525) ... (P529)) for the time set
in (P528).
• Adjust load
• Change limit values ((P525) ... (P527))
• Increase delay time (P528)
• Change monitoring mode (P529)
Switch-off due to undershooting of the 0% adjustment value
(P402) with setting (P401) "0-10 V with switch-off on error 1"
or "....2"
Switch-off due to overshooting of the 100% adjustment
value (P402) with setting (P401) "0-10 V with switch-off on
error 1" or "....2"
83