IMS 5000 Series Manual page 112

N#:
EOT:
SC:
saT:
GPLl:
GPL2:
HLT:
DTL:
DNA controller:
Read address:
Write address:
Free memory:
Radix:
Soft errors:
Hud errors:
FDC base:
Seek verify:
Current value for bytes/sector code (see Command Descriptions)
Number of sectors per track
Number of sectors per track for the format command
Drive step rate (see Appendix A for values)
R/W gap length between data field and next ID field
Format gap length between data field and next ID field
Head load time in ms.
Data length in Read/write table
defaults to 8257 chip
Location in system RAM for disks reads
Location in system RAJ.\1 for disks writes
Available sy stem RAM between top of
progr~
and bottom of
oper ating sys tern.
Numeric values will be displayed in e:i. ther decimal or hexadecimal
form.
4
separate error buffers, one for each drive which will save any
soft errors found. Drive
0
errors are on the left; then Drive
1,2,3.
4 separate error buffers, one for each drive which will save any
hard errors found. Drive 0 errors are on the left, then Drive 1
errors, Drive 2 errors, etc.
Display base address of controller board, 80H for 8", COH for
5" •
Determine if track verification is to be performed af ter a track
or recal command.
"-
\
J
IMS International
5000 Series Microcomputers/7.01.83jPage
110