Dmx Control; Channel Mode - ADJ Element QAIP User Instructions

DMX CONTROL

DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored to their
own individual needs. To control this unit in DMX mode, your controller must be connected to a Wifly
TranCeiver. This is a Wifly unit only. The Element QAIP has 5 DMX modes: 4 channel mode, 5 channel
mode, 6 channel mode, 9 channel mode, and 10 channel mode. See pages 9-14 for each mode's DMX traits.
1. This function will allow you to control each individual fixture's traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until "d.XXX" is displayed. "XXX" represents the
current displayed DMX address. Use the UP or DOWN buttons to select your desired DMX address, then
press the SETUP button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes are listed
below:
• To run the 4 Channel Mode, press the MODE button until "Ch04" is displayed. This is the 4 Channel DMX
Mode.
• To run the 5 Channel Mode, press the MODE button until "Ch05" is displayed. This is the 5 Channel DMX
Mode.
• To run the 6 Channel Mode, press the MODE button until "Ch06" is displayed. This is the 6 Channel DMX
Mode.
• To run the 9 Channel Mode, press the MODE button until "Ch09" is displayed. This is the 9 Channel DMX
Mode.
• To run the 10 Channel Mode, press the MODE button until "Ch010" is displayed. This is the 10 Channel DMX
Mode.
4. Please see hereunder for DMX values and traits.

4 CHANNEL MODE

1 Channel
1
2
3
4
5 CHANNEL MODE
1 Channel
1
2
3
4
5
Value
0 - 255
0 - 255
0 - 255
0 - 255
Value
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
A.D.J. Supply Europe B.V. – www.adj.eu – Element QAIP Instruction Manual Page 9
Function
RED
0% - 100%
GREEN
0% - 100%
BLUE
0% - 100%
AMBER
0% - 100%
Function
RED
0% - 100%
GREEN
0% - 100%
BLUE
0% - 100%
AMBER
0% - 100%
MASTER DIMMER
0% - 100%