Section 1 - Installation; Unpacking The Instrument; Utilities Required; Tools/Equipment Required - Ametek Chandler Engineering 3065 Instruction Manual

Section 1 – Installation

Unpacking the Instrument

Note: Verify all parts listed on packing slip have been shipped with instrument. If
parts are missing, contact Chandler Engineering.

Utilities Required

100-130 VAC/200-240 VAC
10 A
50/60 Hz

Tools/Equipment Required

None

Setting up the Instrument

1. Refer to Figure 1 on the following page while setting up the instrument.
2. Plug the Tachometer Cable from the mixer motor into the matching socket located at the
bottom of the Control Enclosure.
3. Plug the Mixer Power cable into the matching socket located at the bottom of the Control
Enclosure.
4. Place heating jacket around the mixing cup and fasten the Velcro strips.
5. Plug red and black test leads into mixing cup (the leads are interchangeable between the
receptacles, it is only necessary that they both be plugged in).
6. Plug the Test Lead cable into the matching socket located at the bottom of the Control
Enclosure.
7. From the heater jacket, plug the Heater cable into the matching socket located at the
bottom of the Control Enclosure and the thermocouple into the front of the Control
Enclosure.
8. Connect the power cord to an appropriately rated power source in accordance with local
wiring codes.
Caution: Check your power supply (110 VAC or 240 VAC) against your Model 3065
system power rating. Damage can occur if wrong line voltage is applied.
Note: To prevent shock hazard, connect the instrument to an electrical outlet using a
three-prong socket to provide positive ground.
SECTION 1 – INSTALLATION 1-1