Table of Contents
Advertisement
PROGRAMING
- Increment value of T by pressing one of the 4 keys 13 corresponding to each digit.
a) To program, simply set the switch on the side of the unit to the AON@ position.
b) During operation of the timer, change of time delay values:
- taken into account immediately if your display is on the up count (Up) and if the new value is
greater than the time that has already elapsed.
- will be taken into account in the next cycle if you are on the down count display (Down).
c) The unit is supplied with the following configuration: 01.00 s, d (down), C (mode), Prog = ON.
d) If, inadvertently, you enter the unit test procedure with the entire screen or certain segments of the
screen flashing, press the Mode push-button until Bp is obtained on the screen, then press Valid to
return to normal operation.
UTILIZATION PRECAUTIONS:
- The power cables and input circuits must be separate
- A minimum requirement for ventilation and protection from vibration must be provided
- This equipment contains a lithium battery, do not incinerate the unit.
3
Advertisement
Table of Contents
