GE AF-650 GP Operating Instructions Manual page 97

Warnings and Alarms
No. Description
65 Control Board Over-temperature
66 Heat sink Temperature Low
67 Option Module Configuration has Changed
68 Safe Stop
69 Pwr. Card Temp
70 Illegal Drive configuration
77 Reduced power mode
78 Tracking Error
79 Illegal PS config
80 Drive Restored to Factory Settings
6 6
89 Mechanical Brake Sliding
90 Feedback Monitor
91 Analog input 54 wrong settings
243 Brake IGBT
244 Heatsink temp
245 Heatsink sensor
246 Pwr.card supply
247 Pwr.card temp
248 Illegal PS config
249 Rect. low temp.
250 New spare parts
251 New Type Code
Table 6.1 Alarm/Warning code list
(X) Dependent on parameter
1) Can not be Auto reset via H-04 Auto-Reset (Times)
A trip is the action when an alarm has appeared. The trip
will coast the motor and can be reset by pressing the reset
button or make a reset by a digital input (parameter group
E-1# [1]). The origin event that caused an alarm cannot
damage the drive or cause dangerous conditions. A trip
lock is an action when an alarm occurs, which may cause
damage to thedrive or connected parts. A Trip Lock
situation can only be reset by a power cycling.
96
AF-650 GP High Power Operating Instructions
Warning Alarm/Trip
X X
X
X
(X) 1)
(X)
X
X
(X) (X)
X
X
X
(X) (X)
X X
X X
X
X
X
X
Alarm/Trip Lock Parameter
Reference
X
E-07 Terminal 37 Safe
Stop
X
X
SP-59 Actual Number of
Inverter Units
H-24 Tracking Error
Function
X
EC-61 Feedback Signal
Monitoring
X S202
X
X
X
X
X
X
X
X