Setup Pa Settings Band - Apache Labs ANAN-100/D Manual

Apache Labs ANAN-100/D

Setup PA settings Band:

8. Select one of the bands on the PA settings TAB.
9. Ensure you have the Setup ---> Transmit tab ---> Tune control set to 100 and a 150W or larger Dummy Load
connected to the selected antenna port on the ANT/FILTERS setup tab.
10. Press "TUN" (Tune) on the upper left side of the P*SDR™ main display form on your computer.
11. Adjust the band gain value for a MAXIMUM TX Meter "FWD PWR" output reading of 100 watts while using
your suitable Dummy Load. Do NOT use an Antenna for this calibration adjustment.
12. Press "TUN" button again to unkey the radio.
Repeat the above procedure for each Ham Band to properly calibrate the RF CW power output for a MAXIMUM
100 watts.
13. When all bands have been calibrated, remove the Dummy Load and select the antenna of your choice in the
ANT/FILTERS setup Tab.
14. Remember to reduce the "TUN" power wattage setting on the Setup ---> Transmit tab to approximately 9W.
Revision v1.8 April 23, 2013 32 of 70 authors N9VV and KC9XG