Apache Labs ANAN-100/D Manual page 21

Click on the "SETUP" menu selection to configure the P*SDR software.
→ →
Go to GENERAL Hardware Configuration tab and not
the ANAN-100/D Transceiver.
Note: if the IP ADDRESS is 0.0.0.0
you must check your LAN connection.
P*SDR/OpenHPSDR software has not been started
Power button on the rig has not been activated
Also check your LAN connector on the ANAN-100/D to insure that the Link Light on the LEFT side of the LAN
connector is illuminated.
Revision v1.8 April 23, 2013
Apache Labs ANAN-100/D
P*SDR basic display screen
e the IP Address and MAC address that are read from
21 of 70 authors N9VV and KC9XG