Leuze electronic MA 208i Technical Description page 44

Modular interfacing unit for leuze ident and rs 232 devices on ethernet tcp/ip
Table of Contents

Advertisement

Configuration
Information
Version
Firmware date
Table 9.2:
Selected scanner
Gateway mode
State and Control Bytes Used
Separator Length
Separator (hex)
Ring buffer fill level
Received ASCII Frames
ASCII Framing Error (GW)
Number of Received CTB's
Number of Received SFB's
Command-Buffer fill level
Number of send serial frames
Number of send fieldbus frames
Number of invalid commands
Number of serial stack send errors
Number of good serial send frames
Table 9.3:
ND
Data loss
Table 9.4:
ASCII start byte
ASCII end byte1
ASCII end byte2
Rotary switch used
ASCII baud rate
ASCII framing
ASCII warm start status
Table 9.5:
42
Version information.
Firmware date.
General firmware information
Currently selected Leuze device (selected via switch S4).
Transparent or Collective mode.
Displays whether the status and control bytes can be used.
Display of the separator length.
Display of the set separator.
Current fill level of the ring memory in Collective mode (ASCII->Fieldbus). 
1024 bytes max.
Number of received ASCII frames.
Number of received framing errors.
Number of CTB commands.
Number of SFB commands.
Current fill level of the ring memory in Command mode (fieldbus->ASCII).
1024 bytes max.
Number of serial frames sent without CTB/SFB.
Number of frames sent via the fieldbus.
Number of invalid commands.
Number of frames that the serial memory could not send.
Number of frames that the serial memory sent successfully.
General gateway information
Current status of ND bit.
Current status of data loss bit.
Current states of the status and control bits
Currently configured start byte 
(dependent on switch position S4).
Currently configured stop byte 1 
(dependent on switch position S4).
Currently configured stop byte 2 
(dependent on switch position S4).
Rotary switch used.
Currently configured baud rate 
(dependent on switch position S4).
Character length, parity, stop bit(s).
Indicates whether the ASCII memory has detected and accepted a valid
configuration.
ASCII configuration
MA
208i
Leuze electronic

Advertisement

Table of Contents
loading

Table of Contents