Configuration; Connecting The Service Interface; Reading Out Information In Service Mode - Leuze electronic MA 208i Technical Description

Modular interfacing unit for leuze ident and rs 232 devices on ethernet tcp/ip

Table of Contents

Configuration

The connected device is normally configured via the service interface of the gateway with

the help of a suitable configuration program. In these tools, the MA

as a device to enable setting of gateway parameters as well in the usual way via the service

interface.

The respective configuration programs – e.g. for bar code readers the BCL-Config, for RFID

devices the RF-Config etc. – and the associated documentation is provided on the Leuze

home page in the Download area:

www.leuze.com \ download \ identify

Notice!

In order to display the help texts, a PDF viewer program (not included in the delivery contents)

must also be installed. For important information on configuring and on the configurable

functions, please refer to the description of the respective device.

9.1

The RS 232 service interface is connected after opening the device cover of the MA

via the 9-pin Sub-D and a cross-wired null modem cable (RxD/TXD/GND). For connection,

see chapter "Service interface (internal)" on page 32.

The service interface is activated with the help of the service switch and establishes a direct

connection to the connected device with the "DEV" (Leuze device) or "MA" (gateway)

setting.

9.2

 After starting up in the "RUN" switch position, set the service switch of the MA to the

"MA" position.

 Now start one of the following terminal programs: e.g., BCL, RF, BPS Config.

Alternatively, you can also use the Windows tool "Hyperterminal".

 Start the program.

 Select the correct COM port (e.g., COM1) and set the interface as follows:

208i

has been created

208i

Leuze electronic

Table of Contents