Star Micronics XB24-10 User Manual page 48

-
Set line spacing units IBM
<ESC>
[
\ <EOT> <NuL> <NuL>
CNULB
<NuLP -00
1Bh 5Bh
5Ch
OOh OOh <?P
27 91 92
04h
4
OOh
0
OOh
0
The command above sets the units which will be used for setting the amount of line
spacing, where en> is a binary value representing either 180 (l34h) or 216 (D8h).
Line spacing is then defined in terms of either l/180 or l/216 inch units. This
command only becomes effective after an <ES03 or an <ES&J command has
been received.
Set line spacing to 11480 or n/216 inch
<ESC> 3 cm
1Bh 33h <n>
Both
1 27
51 <II> I
The command above allows precise control of line spacing, where <n> is a binary
value. Upon receipt of this command, the line spacing will be set to u1>/180 inch
(when in IBM mode, 02>/216 inch, rounded to the nearest l/360 inch).
Set line spacing to rd60 inch
<ESC> A Cn>
1Bh , 41h
CR>
27 65
<?P
Standard
The command above sets the line spacing in increments of l/60 inch, where en> is
a binary value. On receipt of this command, line spacing will be set to cru/60 inch.
Set line spacing to n/72 inch
cFS> A
CID
1Ch 41h <ID
IBM
28 65 <ID
The command above sets line spacing in increments of l/72 inch, where 01>
represents the number of l/72 inch increments which will constitute a line feed after
the receipt of this command.
40