Star Micronics XB24-10 User Manual page 54

1 Select vertical form unit (VFU) channel Both 1
<ESC>
I
On>
1Bh 2Fh On>
27 47 On>
The command above selects a VFD within which all subsequent <VT> commands
will be executed, where on> is a binary value from 0 to 7. Different sets of vertical
tabs can be stored in different channels using the <ESC> b command, and selected
using this command.
Set VFU vertical tabs
<ESC>
b
On>
. . .
Both _
cd> <NuLa
1Bh 62h
27 98
On>
cm>
-Mb
cnO>
. . .
. . .
all>
cd>
OOh
0
The command above sets vertical tabs inside a VFD, where on> is the VFU channel
(olcmX7) (accessed by the cESC> / <m> command), and subsequent absolute
values (in lines) of vertical tabs (accessed by the <VT> command) are represented
by oto> to otl>. These values must be given in ascending order, otherwise the
command will be terminated. The sequence must end with a <NuL> @Oh). If no
vertical tab values are given between the channel number and the 4IUL>, then all
previous vertical tab positions set for that channel will be cleared.
I Set relative vertical tab positions Both 1
<ESC> e 1 <n>
I lBh< 65h 31h
101 49
The command above will set relative vertical tab positions, where cn> is a binary
value giving the distance in lines between vertical tabs set by this command. The
vertical tabs set by this command are subsequently accessed by the <VT> command.
All vertical tabs previously set are cleared. Instead of the ASCII "l", the binary 01 h
character can be used.
46