Star Micronics XB24-10 User Manual page 59

Set horizontal print posltion
<ESC> f 0
<n>
Both
1Bh 66h
30h
<?D
27 102
48 <#
The command above sets the next horizontal print position, where 01> is a binary
value. The next horizontal printing will take place OI> character spaces (at current
print pitch) from the current horizontal print position.
Set justification mode
Both
&SC>
a <n>
1Bh
61h <to
27 97 <n>
The command above will set the justification mode in which the printer prints
received data, where ur> is a binary or ASCII value in the range OOh (or "0") through
03h (or "3"). The meanings of these values are shown in the table below:
The default (when the printer is first turned on) is left justification.
Produce character space
<ESC> <SF3
C?D
Standard
1 1Bh 20h Cn>
I
27 32 C?P
I
The command above produces a space character, where <Sp> is the ASCII space
character (2Oh), and-> is a binary value from 0 through 127 giving the space width
in dots. When in draft mode, the dot spacing is l/120 inch, and when in LQ or SLQ,
the dot spacing is l/180 inch. If in superscript or subscript printing, the dot spacing
is the same as above, but if in expanded mode, the resolution is half the above.
51