Star Micronics XB24-10 User Manual page 66

Select bit image mode IBM
<ESC>
[
I3
db
cnl>
cm>
<do> . . .
<dn>
1Bh 5Bh
<do> . . .
67h
cdn>
<no> al>
cm>
27
<do>
91 103 edb ull> cm>
. . . cdn>
The command above selects the bit image mode for graphical printing, and gives the
number of bytes to be printed, where cn0, and al> (low byte first) give the number
of graphical data bytes represented by <do> through cdn>, and on> represents the
graphics mode, as represented in the table below:
* Adjacent dots are not printable in these modes
lRelationship of bit number to dot position]
The total number of graphical blocks to be printed is given by the formula
(<nO>+<nl>x256)-1. When the printer is printing bit-image data in IBM mode, the
relationship of bits transmitted to dots printed is as follows:
thus:
both adjecent
58