Special Print Mode Control Codes - Star Micronics XB24-10 User Manual

Special print mode control codes
Select/cancel expanded printing
<ESC> W cn>
1Bh 57h
Cn>
Both
I 27
87
<n>
I
The command above selects or cancels expanded printing, where <n> is a binary or
ASCII value from OOh through Olh or "0" through "1". If <n>=OOh or "O", then
expanded printing is deselected (cancelled), and if ol>=Olh or "1". then expanded
printing is selected for all printing subsequent to the receipt of this command.
Select one-We expanded printing
<ES0 <so>
1Bh OEh
21 14
<so>
Both
Either of the commands above will select one-line expanded print. There are no
parameters. Expanded printing will be performed subsequent to the receipt of this
command until any of the following commands is received: cDC4>, <LD, cESC>
.&Pa, <VT>, cFFb, cESC> d;D, <ES0 W or <FS> E.
$Zancel one-line expanded print
<DC4>
Both
14h
1
20
The command above cancels tbe.one-line expanded print mode set by <SO> or
cESC> <SO>. There are no parameters.