Star Micronics XB24-10 User Manual page 69

I Set MS6 to 0
<ESC>
=
1Bh
3Dh
Standard
27 61
<FS>
=
IBM
3Dh
1
28
61
The command above sets the MSB to 0. There are no parameters. On receipt of this
command, the most significant bit (MSB) of subsequent data will always be set
to 0.
1 Cancel MSB control
Both 1
rcESC>
I
1Bh 23h
27 35
The command above cancels software control of the MSB. There are no parameters.
On receipt of this command, software control of the most significant bit (MSB) by
the cESC>>, <ESC>= (standard) or <FS>= (IBM) commands, will be cancelled.
Select zero style
<ESC>
1Bh 7Eh
*
27 126
Both
The command above selects the style in which zeroes will subsequently be printed,
where cn> is either a binary value of OOh or Olh or an ASCII value of "0" or "1". If
01> is OOh or "O", then "normal" (non-slashed) zeroes will be printed, but if it is 01 h
or "l", then the "computer-style" (slashed) zero style wiIl be printed (this overrides
the Memory Switch setting, in Chapter 3).
61