Star Micronics XB24-10 User Manual page 71

Set printer on line
Both
<DCl>
llh
17
Thecommandabovesetstheprinteron-lineaftera<DC3>command(above). There
are no parameters.
Deselect printer (IO" carriage model only)
IBM
<ESC>
Q $
1Bh 51h
24h
27 81 36
The command above deselects the printer. There are no parameters. This command
will deselect the printer, forcing it to disregard all data and command codes until a
cDCl> (1 lh) command is received to put the printer back on-line. This command
applies only to the model of printer equipped with a 10" carriage.
Deselect printer (15" carriage model only)
IBM
<Esc>
Q
#
1Bh 51h 23h
27 81 35
The command above deselects the printer. There are no parameters. This command
will deselect the printer, forcing it to disregard all data and command codes until a
4X1> (11 h) command is received to put the printer back on-line. This command
applies only to the model of printer equipped with a 15" carriage.
Stop printing IBM
cESC>
j
1Bh 6A
27
106
The command above forces an off-line status. There are no parameters. The printer
goes off-line, and the contents of the buffer are printed. This command differs from
the two previous commands @eselect printer) in that when this command has been
received, the parallel interface SELECT signal goes low, and the BUSY signal goes
high (ie no data can be received from the computer). It is necessary to press the
0~ LIP ) button to reset the printer.
63