Assembly, Connection And Putting Into Operation; Assembly - Honeywell DL230 Operating Instructions Manual

34
Assembly, Connection and Putting into Oper-
5
ation

5.1 Assembly

The DL230 can be operated as associated apparatus for ATEX zone 0
or 1 and inside ATEX zone 2. Notice the yellow ATEX marking on each
device.
When using in zone 2, the following warning applies:
DANGER!
The DL230 must not be used in Zone 0 or Zone 1!
WARNING!
When using in Zone 2 may present a risk of explosion!
– Do not open when an explosive atmosphere may be
– Potential electrostatic charging hazard: Do not rub
– Notice the intrinsic safety parameters of chapter 3.7.3.1
The DL230 can either be mounted on a wall or a pipeline.
Should problems arise during assembly, e.g. with regard to
the selection of suitable assembly tools, please contact our
customer service team (see "General" chapter).

Assembly, Connection and Putting into Operation

present!
against the display-window!
when connecting the serial interface.