Honeywell DL230 Operating Instructions Manual page 46

46
–
Once you have changed all of the digits, press the ENTER key in order
to confirm your entry. The input value can be deleted by using the ESC
key.
5.3.1.5 Configuration of the outputs
The cp values (pulse constants) for the outputs can also be
configured using the enSuite software.
The following functions are preset ex-factory for the outputs:
Output Function
DA1 Pulse output for volume "V1" (cp.A1= 0.1)
DA2 Pulse output for volume "V2" (cp.A2= 0.1)
The cp value of an output indicates how many pulses are emitted per cubic
meter. A cp value of 0.1/m3 (0.1 pulses per m3) means that e.g. a pulse is
emitted per 10m3.
To change the cp values for output 1 or output 2, move the cursor to the
"Serv." register and go to "cp.A1" (for output 1) or "cp.A2" (for output 2) via
the following path:
Serv.  Outputs  Output 1  cp.O1
Serv.  Outputs  Output 2  cp.O2
or
Press the ENTER button  a digit of the cp value will flash.
◼
◼ Move the cursor to the digits using the  or  arrow keys and update
them using the  or  arrow keys.
◼
Press ENTER, so that the value setting is confirmed. The input value can
be deleted by using the ESC key.
Aside from the settings described here, a range of other func-
tions can be configured for the outputs, e.g. status information
or time-synchronous pulses.
A complete description can be found in the DL230 Application
Manual that can be downloaded under www.elster-
instromet.com.
5.3.1.6 Setting the daylight-saving time
◼
Move the cursor to the "Serv." register and to the "MdTim" value (day-
light saving mode) via the following path:
Serv.  Date and time  MdTim
Press the ENTER button  the set value flashes.
◼
Change the value using the arrow keys  or :
◼
Assembly, Connection and Putting into Operation