Promix-SM308
3. SET OF DELIVERY
1 – Lock
2 – Latch
3 – Self-tapping screw 3.5x15 (cup
4 – Operating manual
head)
Check completeness of the lock set when buying! After buying, the
manufacturer will not accept claims related to incomplete set.
4. DESIGN AND PRINCIPLE OF OPERATION
The lock Promix-SM308 is produced in a normally closed version, i.e., it is in the closed state
when de-energized and opens as supply voltage is applied.
The lock is mounted on inner surfaces of the locker transversely to the door and is operable in
both vertical and horizontal positions. The mating part (latch) is mounted on the door.
As the door is closed, the latch is inserted in the lock and becomes blocked therein. As supply
voltage is applied, the lock deblocks the latch and pushes it with a built-in pusher, which allows to
eliminate mounting of a handle on the door.
The spring-loaded pusher of the lock is connected to the door position sensor. The operating
principle of the sensor is described in 6.3.
5. TECHNICAL DATA
5.1
OPERATING CONDITIONS
The lock operation environment must be explosion-safe, free of current-conducting dust or
gases that cause metal corrosion and destroying insulation of current conductors and electric
elements, free of current-carrying dust or water vapor, and preventing ingress of water, steam,
fuel and lubricants.
Climatic conditions of operation – У3.1 as per GOST 15150-69 with extended temperature
range:
ambient temperature: from -30 to +50 °С;
Relative air humidity: not higher than 98% at 25°С or lower temperatures without moisture
condensation and hoar-frost formation;
installation indoors or outdoors excluding ingress of moisture, dust, dirt, etc. inside the lock.
2
1 pc.
1 pc.
Pusher
5 pcs.
1 pc.
2
1
.
Base edge