A One-Shot Vertical Tab Command; Table 7-3 Vertical Tab Commands - Star Micronics SG-10 User Manual

I
This doesn't confuse SG- lo/ 15-it advances the paper to the next
tab position which happens to be the first tab position on the
next page. That's nice, isn't it?
n A one-shot vertical tab command
There's a one-time vertical tab command that works just like
the one-time horizontal tab command. It is < ESC > "a"
CHR$(n), and it causes the paper to advance n lines. It doesn't
change the settings of the verti,cal tabs.
Table 7-3
Vertical tab commands
Function Mode Control code
Advance paper to next tab STAR CHR$( 11)
position
IBM CHR$( 11)
Set
vertical tabs at
nl, n2, etc. STAR < ESC 5 "I"' CHR$(nZ)
CHR$(n2)...CHR!$(O)
IBM
< ESC > "B" CHR$(nl)
CHR%(n2)...CHR$(O)
-
-
-
-.
-
Advance paper
n
lines
STAR < ESC > "a" CHR$(n)
IBM < ESC > "a" CHR$(n)
Note:If your computer does not support lowercase characters, use
CHR$(97) for "a."
SUMMARY
Control code Function
CHR$(9)
Horizontal tab
< ESC > "D" nl n2 n3 . ..CHR!$(O) Set horizontal tabs
< ESC > "b" n
One-time horizontal tab of II
spaces
< ESC > "M" y1 Set left margin (for STAR
mode)
< ESC > "1" n Set left margin (for IBM
mode)
< ESC > "Q" n
Set right margin
CHR$( 11)
Vertical tab
< ESC > "P" nl n2 n3 . ..CHR$(O) Set vertical tabs (for STAR
mode)
-_
I -
-
-
-
< ESC > "B" nl rz2 n3 . ..CHR!$(O) Set vertical tabs (for IBM
mode)
< ESC > "a" n One-time vertical tab of n lines
-
66