Other Printer Control Commands - Star Micronics NX-1020 User Manual

OTHER PRINTER CONTROL COMMANDS
Set MSB to I
Mode ASCII
Decimal Hexadecimal
Std. <ESC> ">"
27 62 1B 3E
Sets the most significant bit of each subsequent byte received to 1,
allowing users with a 7-bit interface to access characters with ASCII
codes greater than 127.
Set MSB to 0
-
Mode ASCII
Decimal
Hexadecimal
Std.
<ESC> "="
27 61 1B 3D
Sets the most significant bit of each subsequent byte received to 0.
Accept MSB as is
Mode ASCII
Decimal Hexadecimal
Std. cESC> "P'
27 35 1B 23
Cancels the preceding commands and accepts the most significant
bit as it is sent to the printer.
Delete last character sent
Mode ASCII
Decimal Hexadecimal
Std. <DEL>
127 7F
Deletes the last character received. Ignored if the last character -
received has already been printed, or if the last character received
_.
was all or part of a command.
Cancel last line
Mode 1 ASCII
1 Decimal
1 Hexadecimal
1 Both 1 <CAN>
1 24 1 18
1
Deletes the last line currently present in the print buffer.
76