Other Printer Control Commands - Star Micronics LC-10 User Manual

OTHER PRINTER CONTROL COMMANDS
Set MSB to 7
Mode
ASCII Decimal Hexadecimal
Both <ESC'
.' > "
21 62
IB 3E
Sets the most significant bit of each subsequent byte received to 1, allowing
users with a 7-bit interface to access characters with ASCII codes greater
than 127.
Set MSB to 0
Mode ASCII Decimal
Hexadecimal
Std. <ESC>
" = 13
27 61 1B 3D
IBM
<FS> "E"
28 61 1C 3D
Sets the most significant bit of each subsequent byte received to 0.
Accept MSB as is
Mode ASCII
Decimal Hexadecimal
Both <ESC>
"#"
27 35 1B 23
Cancels the preceding commands and accepts the most significant bit as
it is sent to the printer.
Delete last character sent
Mode
ASCII Decimal
Hexadecimal
Both <DEL>
127
IF
Deletes the last character received. Ignored if the last character received
has already been printed, or if the last character received was all or part
of a command.
Cancel last line
Mode ASCII Decimal
Hexadecimal
Both <CAN> 24
18
Deletes the last line currently present in the print buffer.