Table of Contents
Advertisement
Check
Are you trying to feed paper
using the front panel buttons
while the
ON LINE
indicator
is illuminated?
Is the paper too thick?
Possible remedy
You can only feed paper in this way when the printer is
off-line. Set the printer off-line and then feed paper.
There are limits to the thickness of paper that can be fed
in this way. Try using thinner paper.
If the ASF is not operating or is not feeding paper correctly, check the
following:
Check
Has the ASF option been
selected
with
the
EDS
switch?
Is the release lever set to the
C position?
Is
the
ASF
correctly
mounted?
Is paper caught up near the
print
head?
Possible remedy
Select this option.
The release lever should be set to the single-sheet
position.
Make sure that the ASF is properly seated on the printer.
Stop printing, remove the jammed sheet (you may have
to remove the ASF for this). and continue.
lf the left and right guides are too close together, the
paper will not feed smoothly. Move them a little further
) ~~rr~r~~
1 aparttoallowthepapertofeedfreely.
The ASF's paper feed hopper and stacker can hold 50
sheets each. Make sure that there is no more paper than
this in either the hopper or stacker.
Was the paper fanned before
If this is not done, paper jams may occur. Remove the
being fed into the ASF?
stack of paper from the ASF and fan it before reinsert-
w
Only new, uncreased
paper should be used with the
Are you trying to feed paper
using the front panel buttons
while the
ON LINE
indicator
You can only feed paper in this way when the printer is
off-line. Set the printer off-line and then feed paper.
There are limits to the thickness of paper that can be fed
in this way. Try using different paper.
111
Advertisement
Table of Contents
