Table of Contents
Advertisement
If the paper park function does not appear to be working correctly, check the
following:
Check
Possible remedy
Is the paper release lever in
the C
position?
The paper release lever must be set to the & position
after the fanfold paper has been parked.
Has the fanfold paper been
properly parked?
Make
sure that the POWER
indicator comes on flashing
after the fanfold paper has been parked.
If text is being printed all on one line, or with extra blank lines, check the
following:
Check
Is the text all on the same
line?
Is text being printed
with
extra blank lines?
Possible remedy
Carriage
returns
are
not
being
expanded
to
<CR> + <LF> pairs. Check the EDS setting
and
CorreCt.
Two line feeds are being printed. Make your software
printjust acarriagereturnor
(if this is not possible). set
the AUTO LF to OFF with the EDS setting.
If the page length and margins are not what is expected, check the following:
Use the Micro Feed function to adjust the print position
Use the EDS switches to set up the correct page length,
112
Advertisement
Table of Contents
