Data Bits Setting; Network Menu; I/O Timeout Setting - Ricoh Aficio 401 Operating Instructions Manual

Data Bits Setting Screen
When you press the [Change] button for the Data Bits option, the Data Bits
Setting screen displays.
You use this screen to specify the number of data bits in each character.
The options are as follows:
8
7
The default is 8.
Note: You must set the stop bits for the serial port to the same stop bit
setting as the host.

Network Menu

When you press the [Network Menu] button from the Setup menu, the
Network menu displays. You use the Network menu to specify the network
timeout setting you want to use.
The current value for the option displays in the box to the right of the option
on the screen. To change the value for the option, press the [Change]
button located beside the option. The Setting screen for that option displays.
I/O Timeout is the only option available on this screen.
I/O Timeout Setting Screen
When you press the [Change] button for the I/O Timeout option, the I/O
Timeout Setting screen displays.
You use the numerical keys to change the value for the number of seconds
after which an incomplete print job should end and the next port in the
polling sequence should be set. The valid range is 5 to 300, entered in
increments of 1. The default is 30 seconds.
USING THE CONTROL PANEL
2-41