Cleaning The Milk Container; Menu Settings; Rinsing; Setting The Language - V-ZUG 74A Instructions Manual

8. Replace the drip tray and grounds container.
9. Close the service door.

Cleaning the milk container

Important! Always clean the tubes inside the milk
container (C) when you prepare milk.
If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary.
Clean the container each time you prepare milk as described in
Note 3 in the section "Making cappuccino".
All components are dishwasher safe, placing them in the top
basket of the dishwasher.
1. Turn the lid of the milk container clockwise then remove it.
2. Remove the milk spout and intake tube.
milk intake tube
3. Remove the froth regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid.
Make sure there are no milk residues left inside the holes
and the groove on the fine end of the froth regulator.
5. Check that the intake tube and spout are not clogged with
milk residues.
6. Replace the froth regulator, milk spout and intake tube.
7. Replace the milk container lid.
spout
hole

MENU SETTINGS

When you access the settings menu by pressing the P / ESC but-
ton (B7), the following menu items are available: Rinsing, Set
language, Energy Saving, Adjust time, Auto-start, Auto-off, Set
temperature, Water hardness, Statistics, Default values, Descale.

Rinsing

This function enables you to obtain hotter coffee.
Proceed as follows:
• When you turn the appliance on, if you want to make a
small cup of coffee (less than 60 cc), preheat the cup by
rinsing it with hot water.
• If on the other hand more than 2/3 minutes have passed
since the last coffee was made, before requesting another
coffee, you must preheat the infuser by first pressing the P
/ ESC button (B7) to enter the menu then the ▽ and △
buttons (B5 and B6) to select the "RINSING" function.
Press the OK button (B4). "RINSING PRESS OK" is displayed.
Press the OK button (B4) again.
Deliver the water into the underlying drip tray or alterna-
tively use this water to fill (and then empty) the cup to be
used for the coffee to preheat it.

Setting the language

To modify the language of the display, proceed as follows:
1. Press the P / ESC button (B7) to enter the settings menu.
2. Press the ▽ and △ buttons (B5 and B6) until "SET LAN-
GUAGE" is displayed;
3. Press the OK button (B4);
4. Press the ▽ and △ buttons (B5 and B6) until the required
language is displayed;
5. Press the OK button (B4) to confirm;
6. Press the P/ ESC button (B7) to exit the menu.
17
groove
froth regulator
hole
EN