JUMO LOGOSCREEN nt Interface Description page 28

4 Modbus protocol description
28
Error code Description
Error list: General input and output
14 please confirm with the ENTER key
15 invalid number of places
16 the entry contains invalid characters
17 value is outside the limits
18 segment not programmed correctly
19 password error
Error list: Profibus job processing
20 busy flag from master not reset
21 impermissible job
22 error on data acceptance
23 no cyclical data available
24 structure length is not permitted
25 header ID is not permitted
Error list: Keypad and program lock
26 keypad is locked
27 programming is inhibited
28 error in ser. EEprom (calib)
29 hardware error: HAND + AUTO locked
30 editing not permitted when program is active
31 copying not permitted when program is active
32 HAND is not permitted during AUTO delay time
33 segment change! Screen must be generated
34 no DB number for screen generation from PLC
35 no DB number for process values from PLC
36 printer busy or not ready
37 setpoint 1 was not programmed
38 set up the printer (config. / interface)
39 only possible when device is in HAND mode
40 self-optimization already running
41 time axis expired or not programmed