Daikin VRV IV-S RXTQ-TAVJU Series Service Manual page 97

SiUS331604E
Mode First
No. Code
(∗2) No.
13(23) 0 Setting of normal airflow
1 Selection of airflow direction
(Set when a sealing material kit has been installed.)
2 Swing pattern settings
(In case of an infrared floor sensor is installed)
3 Operation of downward flow flap
4 Setting airflow position
5 Setting of static pressure selection
6 External Static Pressure Settings
4 (∗6) Setting of Humidifier / Air Purifier Fan Tap
14
(24)
5 (∗6) Residual Operation Time
15(25) 1 Thermostat OFF excess humidity
2 Direct duct connection
(when the indoor unit and Heat Reclaim
Ventilator are connected by duct directly.) (∗5)
3 Drain pump and humidifier interlock selection
5 Selection for individual ventilation setting by
remote controller
1b (2b) 3 Display of Contact Center
4 Display of error codes on the remote controller
12 Key-lock pattern settings
14 Setting restricted/permitted for airflow block
1c (2c) 0 Room temperature display
Note:
1. Settings are made simultaneously for the entire group, however, if you select the mode No. inside
parentheses, you can also set units individually. Setting changes however cannot be checked except in the
individual mode in parentheses.
∗2. The mode numbers inside parentheses cannot be used by wireless remote controllers, so they cannot be set
individually. Setting changes also cannot be checked.
3. Do not make settings other than those described above. Nothing is displayed for functions the indoor unit is
not equipped with.
4. 88 or Checking the connection. Please stand by. may be displayed to indicate that the remote controller is
resetting when returning to normal mode.
∗5. If the setting mode is set to Equipped, heat reclaim ventilation fan conducts the fan residual operation by
linking to the indoor unit.
∗6. Only for FXTQ
∗7. For FXTQ: Factory setting is 02.
∗8.
Thermostat
ON
Field Setting
Description
Set temperature
Thermostat
OFF
<Ttsoff>
<Ttson>
Second Code No.
01 02
N H
F (4 directions) T (3 directions)
All direction —
synchronized
swing
Equipped Not equipped
Draft prevention Standard
Standard High static
pressure
Refer to page 94.
Remote
H tap
controller setting
30 seconds 60 seconds
Not equipped Equipped
Not equipped Equipped
Not equipped Equipped
Not equipped Equipped
Displayed Not displayed
— Two-digit display
No operation No operation
allowed (Cancel allowed (Cancel
procedure is procedure is not
displayed.) displayed.)
Refer to page 96.
Room Room
temperature is temperature is
not displayed displayed
Field Setting from Remote Controller
03 04
S —
W (2 —
directions)
Facing swing —
— —
Ceiling —
Soiling
prevention
— —
— —
120 seconds —
— —
— —
— —
— —
—
—
— Four-digit
display
No menu No menu
operation is operation is
allowed allowed any
(Cancel time.
procedure is
displayed.)
— —
Details
No.
(19)
(20)
(21)
(22)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
84