Control Codes Used For Peripheral Units - Star Micronics SP300 Series Programmer's Manual

7-6. Control Codes Used for Peripheral Units

FUNCTION
CODE
DEFINITION RANGE
OUTLINE
NOTE
FUNCTION
CODE
OUTLINE
FUNCTION
CODE
OUTLINE
Adjust drive pulse width for peripheral unit 1
<ESC> <BEL> n1 n2
(1B) (07) n1 n2
H H
1 n1 127, 1
Adjusts drive pulse width for peripheral devices requiring
other than standard 200 ms pulse time and delay time
Energizing time = 10 n1 (ms)
Delay time = 10 n2 (ms)
Executed by <BEL>, <FS> codes.
ON
OFF
Adjustment is not necessary for standard cash drawers in the
U.S.A. market.
Deferred drive command for peripheral unit 1
<BEL>
(07)
H
Executes drive pulse for peripheral unit 1 (deferred).
Immediate drive command for peripheral unit 1
<FS>
(1C)
H
Executes drive pulse for peripheral unit 1 (immediate).
This code differs from the <BEL> code as follows:
When the printer receives an <FS> code, the command is
executed immediately. The <BEL> code is stored in the data
buffer in the same manner as other codes, and executed in the
order in which they are received.
n2 127 (default setting n1 = n2 = 20)
10 n1 (ms)
Printing and paper feed
are prohibited.
– 49 –
10 n2 (ms)