Validation Printing (Models With Validation Function Only); Operating Method - Star Micronics SP300 Series Programmer's Manual

5. VALIDATION PRINTING (Models with validation function only)

This printer can print one line of validation printing.

5-1. Operating Method

B
A
A: Standard position (one sheet)
B: Validation printing or copying
Fig. 5-1 Position of the adjust lever
Front cover
Fig. 5-2 Loading the paper
Adjust lever
Rear cover
1 Open the front cover, pull the adjust
lever one notch from standard posi-
tion A toward the operation panel
side position B.
When you cannot find standard po-
sition A, push the lever as far as
possible toward the rear cover, and
pull it 2 notches after having pressed
it down. The lever is now in standard
position A.
2 Mount the front cover.
3 Set the printer for the validation
print mode. In this instance, the
buzzer gives tow short beeps.
4 Make sure that the ON LINE lamp
is flashing.
5 Align the right edge of paper with
the right end of the tear bar then
insert the paper from the top.
6 The printer starts printing approx. 1
second after the paper is loaded.
7 When printing is completed, pull
the paper upward and remove it
from the printer.
Right end
of the tear bar
Note: When printing a roll paper, also
set the adjust lever at position B.
– 26 –