Setpoint Limit Settings - Lennox V0STAT51P-3 Installation & Operation Instructions

Setpoint Limit Settings

Setup auxiliary and alternate heat source activation from the controller.
1. Tap the Setpoint Limit button to enter the setpoint limit screen.
2. Slide the temperature value below Minimum Cooling Setpoint and select the minimum cool-
ing setpoint. The highlighted value in the middle is the currently selected parameter. After
setting the minimum cooling setpoint, the user will be unable to set a value lower than this
set value when adjusting the setpoint in Cooling mode and Dry mode, or the cooling setpoint
in Auto mode.
3. Slide the temperature value below Maximum Heating Setpoint and select the maximum of
the heating setpoint. The highlighted value in the middle is the currently selected parameter.
After setting the maximum heating setpoint, the user will be unable to set a value higher
than this set value when adjusting the setpoint in Heating mode, or the heating setpoint in
Auto mode.
Figure 105. Setpoint Limit Settings
81