Rudder Control Horn Installa- Tion - Black Horse Model Impulse 100TD Instruction Manual

Impulse 100TD
- Item code: BH 121
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Bottom side.
20
.
Cut the covering
away from the slot.
Temporary pin to
keep hinge centered.
Instruction Manual
 When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
RUDDER CONTROL HORN INSTALLA-
TION.
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of Rudder.
A+B Epoxy
glue.