Download Print this page

Rudder Control Horn Installa- Tion - Black Horse Model TWISTER Instruction Manual Book

All balsa ply wood construction covered with oracover, wingspan 1,380 mm 54.3 in. length 1,100 mm 43.3 in. weight 2.15 kg 4.73 lbs. radio 04 channels servo 05 servos engine 32-40 cu.in. 2 stroke 52 cu.in 4 stroke

Hide thumbs Also See for TWISTER:

Instruction manual book (25 pages)

Table Of Contents

Table of Contents

TWISTER

Epoxy glue

C/A glue

Horizontal

90º

Stabilizer.

6) When you are sure that everything is a

aligned correctly, mix up a generous amount

of 30 minute epoxy. Apply a thin layer to the

slot in the mounting platform and to the vertical

stabilizer mounting area. Apply epoxy to the

lower rudder hinge. Set the stabilizer in place

and re-align. Double check all of your

measurements once more before the epoxy

cures. Remove any excess epoxy using a

paper towel and rubbing alcohol and hold the

stabilizer in place with T-pins or masking tape.

Allow the epoxy to fully cure before proceeding.

RUDDER CONTROL HORN INSTALLA-

way of aileron control horn. Please see pic-

tures below.

Nilon

control clasp.

Vertical

Stabilizer.

Instruction Manual

TION.

Rudder control horn install as same as the

M3 lock nut

3mm x 40mm.

Control horn of Rudder.

Mark point

Remove

covering

Table of Contents

This manual is also suitable for:

Bh.22

Rudder Control Horn Installa- Tion - Black Horse Model TWISTER Instruction Manual Book

Related Manuals for Black Horse Model TWISTER

Related Content for Black Horse Model TWISTER

This manual is also suitable for:

Table of Contents