Rudder Control Horn Installa- Tion; Rudder Pushrod Installation - Black Horse Model PIPER CUB NC 76510 Instruction Manual Book

PIPER CUB.
Pen.

4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizontal stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
Remove covering.

5. Put the vertical stabilizer back in place.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90 degree to the
horizontal stabilizer.
Horizontal 90º
Stabilizer.
Epoxy glue.

aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the vertical
stabilizer mounting area. Apply epoxy to the
lower rudder hinge. Set the stabilizer in place
and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceeding.
RUDDER CONTROL HORN INSTALLA-
way of aileron control horn. Please see pictures
below.
Vertical
Stabilizer.

of aileron pushrod.
INSTRUCTION MANUAL
6) When you are sure that everything is a
C/A glue.
TION.
Rudder control horn install as same as the
Rudder
control horn.

RUDDER PUSHROD INSTALLATION.

Rudder pushrod install as same as the way
Elevator pushrod.
Rudder pushrod.
19