Table of Contents
Advertisement
CAP 232.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
Epoxy glue.
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
RUDDER CONTROL HORN INSTALLA-
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Nilon control clasp.
INSTRUCTION MANUAL
C/A glue.
6) When you are sure that everything is a
TION.
3mmx60mm.
M3 lock nut.
Control horn of Rudder.
21
Advertisement
Table of Contents
