Operation; Handling - Deprag MICROMAT-E 320E19-0008 Operating Instruction Booklet

5

Operation

Trained personnel may operate the EC-Screwdriver Spindle only.
Proceed with the operating according to the Operating Instructions of the EC-
Screwdriving System - Operation.
6

Handling

DANGER
Make sure to always disconnect the Screwdriver Spindle
from the power supply, when performing maintenance,
adjustments or disassembly.
Attention:
The screwdriver spindle will heat-up in relation to its average
load respectively sequence of operation. If the selection of the
type of Screwdriver Spindle is incorrectly or its operation is not
appropriate for the application, the tool might overheat which
could result in injuries (burnings).
NOTE
If the guide bolt is not required and will be removed, the
thread M5 of the screwdriver housing is to seal with a cylinder
head screw (M5x8).
thread M5 of
screwdriver housing
13