General - Deprag MICROMAT-E 320E19-0008 Operating Instruction Booklet

3

General

The EC-Screwdriver 320E... is part of the EC-Screwdriving System.
The essential characteristics of this screwdriver series are:
·
brush-less EC-Drive with commutator over encoder
·
torque- and angle-controlling
The EC-Screwdriving System is designed for the use in an industrial envi-
ronment for a maximum torque of 0,2 / 0,5 resp. 0,8 Nm (depending on the
screwdriver type – see chapter Technical Data).
This system is especially well suited for the use in an assembly area which
has a high demand in regards to flexibility of the screw-assembly and docu-
mentation possibility.
The EC-Screwdriving System mainly consists of two components. They are:
·
the EC-Screwdriver Spindle of the series 320E...
·
the sequence controller AST10-1 with integrated amplifier
Further accessories – see Operating Instructions of the EC-
Screwdriving System.
The operation of the screwdriver spindle requires a programm-
able sequence controller (AST10) with integrated amplifier and a
motor cable. The cable is available in different lengths.
The sequence controller offers standard screwdriving programs for tightening
screws to a specific torque value respectively loosening at a specific angle
value. Their parameters are adjustable directly via the controller's keyboard.
Special screwdriving sequences are easy to create: standard assembly steps,
already stored in the controller, can be selected and comfortably built up to
form a complete assembly process. This happens via the integrated web ser-
ver's PC operator board.
·
No special PC software is required – only a normal web browser (such
as MS explorer) and an Ethernet port.
Additional software modules for documentation and screw join analysis (data
logging, graphics, etc.) are available as optional accessories.
·
Also optionally available is an update service for the die AST10 which
provides continuous update of the controller's function and control soft-
ware.
10