What To Do If Your Filter Tank Does Not Sit Level On The Floor - Clean Water Systems Terminator Installation & Start?Up Manual

Terminator Iron Filter Installation & Startup Guide

What to Do If Your Filter Tank Does Not Sit Level on the Floor

Your black filter tank base is not glued to the bottom of your tank. Occasionally tank bases will become
crooked during shipment. If you find that that your tank does not sit level on the floor, you can easily adjust it
by holding the empty tank and rapping it on a concrete or solid floor once or twice in order to level it.
Don't Over-Tighten 2510 control When Installing on Tank
Please Note: When installing Fleck 2510 backwash control-timer valve on to the top of
the filter tank please do not over-tighten.
Tighten with hands, there is no need for a pipe wrench or other wrench.
The control valve is sealed with the o-ring on the base of the control valve. Once you
hand-tighten it so the o-ring has sealed against the top of the tank, continue to
tighten for approximately another ¼ turn until tight.
If the control valve is over-tightened and leaks, the black Slip Ring (see control valve
manual, it is #26, part 19197 in the exploded view of the control valve) will need to be
replaced.
Page 15 www.cleanwaterstore.com
Rev 042414