GE MULTILIN 269 MOTOR MANAGEMENT RELAY Series Instruction Manual page 73

3 SETUP AND USE
6
STATUS = XXXXXX STATUS = XXXXXX
FOR: XXXXXXXXXXXX SWITCH FOR: XXXXXXXXXXXX SWITCH
This line can be used to check the status (either OPEN or SHORT) of any of the following terminals:
EXT.RESET, EMG.RESTART, ACCESS, SPEED, DIFF., or SPARE
7
SOFTWARE ACCESS = OFF SOFTWARE ACCESS = OFF
ACCESS STATUS: ENABLED ACCESS STATUS: ENABLED
This line will display the access status as ENABLED or DISABLED, reflecting whether setpoints may be
stored or not. Storing a value of OFF for "Software Access" defeats the software access feature. Access
is then strictly a function of the access jumper. Once the status reflects ENABLED, a value may be
stored for "Software Access". This value (1–500) will activate the software access feature. The value
stored will remain on the screen until the user moves to a new line, presses the CLEAR button, or ac-
cess becomes disabled. The display of the Software Access code will then revert to "0" so that the code
cannot be viewed (a value of "0" may never be stored for this setpoint). The Access Status will remain
enabled for approximately 4 minutes after the last key is pressed, or until the access jumper is removed.
To enable access again, the user must ensure the access jumper is installed and then store his software
access code.
0–500, in increments of 1, or OFF (A value of OFF disables the Software Access feature. A value of "0"
Factory Value = OFF.
8
SERVICE USE ONLY SERVICE USE ONLY
CODE = XX CODE = XX
This line is used by GE Multilin service personnel for calibration and service to the 269 relay.
9
CAN.SERVICE: 905-294-6222 CAN.SERVICE: 905-294-6222
http://www.ge.com/edc/pm http://www.ge.com/edc/pm
Canadian service phone number and web site address.
10
ENCRYPTED SECURITY ENCRYPTED SECURITY
ACCESS CODE = XXX ACCESS CODE = XXX
In the event that the user should forget or lose his Software Access code, the value displayed on this line
may be used by a GE Multilin Service person to decipher and notify the user of his Software Access
code.
11
MULTILIN 269 RELAY MULTILIN 269 RELAY
REVISION REVISION
This is the 269 relay firmware revision identifier line.
12
269 SERIAL NUMBER 269 SERIAL NUMBER
SERIAL #: D20 X XXXX SERIAL #: D20 X XXXX
This is the 269 relay serial number identifier, where:
D: Hardware revision
20: Product code
X: Last digit of production year
XXXX: Four digit serial number
3-34
Setpoints, Pg. 6
indicates that the feature is enabled).
269.XX.X 269.XX.X